Another addition for the Heavy-Duty world
After releasing the Bench protocol for Delphi ETC3 (KWP) control units, that can be found on DAF trucks, we’re adding something new: the OBD Full support.
Thanks to this new Flex software update (version 7.20.0.0), you can now read quickly and safely Internal Flash and External Flash memories (including the virtualized EEPROM) directly via the diagnostic port of the vehicle.
With Flex you can modify, repair, and clone the unit in just a few minutes:
– easily elaborate engine maps
– remove trouble codes
– clone a damaged ECU on a used but still working unit
You can perform all these operations without the need to open the unit nor to remove it from the vehicle: just use the OBD cable for trucks (FLX2.65) to get access to all advanced functions, easily and without risks.
Some of the supported vehicles:
- DAF XF106 (430) 12.9L 428PS
- DAF XF106 (440) 10.8L 435PS
- DAF XF106 (530) 12.9L 530PS
Writing Time
~2 minutes
Read Time
~ 4 minutes
This new protocol is available for the following software packages:
OBD FULL
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.15M – SW Flex Heavy Duty OBD/Bench/Boot Master
- FLS0.15S – SW Flex Heavy Duty OBD/Bench/Boot Slave
Newly added protocols:
OBD FULL
- EXCLUSIVE: DAF Delphi ETC3 (KWP) MPC5566 Read/Write/Checksum Calulation Internal Flash (EEPROM emulated), Read/Write External Flash, Full Backup
Check the Privacy Policy below to subscribe to Newsletter
