Version 7.16.0.0 of Flex Out Now with a New Vitesco GPEC4LM Exclusive
A new exclusive for Flex, once again: new protocols releaset to program Vitesco Technologies GPEC4LM control units in Boot and OBD.
Use the Boot mode to access Internal Flash and External EEPROM memories, ensuring a comprehensive programming of control unit data.
Unlock the ECU without any additional fee thanks to the integrated feature, then move rapidly to programming in OBD.
With this new OBD solution for Flex, you can read and write the map zone of the engine unit directly via the diagnostic port, ensuring better performances for your vehicle.
And that’s not it: we will soon release the Unlock for Continental GPEC2, GPEC2A, GPEC3, GPEC4, GPEC4LM ECUs, enabling OBD programming.
Please note: the SGW bypass cable for FCA is required to work via the diagnostic port
Some of the supported vehicles:
- Alfa Romeo Tonale 1.3L Plug-in Hybrid 180PS
- Fiat 500X 1.5L FireFly Hybrid 130PS
- Jeep Compass 1.5L Plug-in Hybrid 150PS
- Jeep Renegade 1.3L Plug-in Hybrid 180PS
Writing Time
~1 minute
Read Time
~2 minutes
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
BOOT
- FLS0.4M – SW Flex Boot Nexus MPC5xxx Master
- FLS0.4S – SW Flex Boot Nexus MPC5xxx Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
- FCA Vitesco GPEC4LM SPC5674 Read/Write/Checksum Calculation Internal Flash, Read External EEPROM
BOOT
- FCA Vitesco GPEC4LM SPC5674 Read/Write/Checksum Calculation Internal Flash, Read/Write External EEPROM, Full Backup, OBD Unlock
Bug fixes:
- Added new CRC type for FCA Marelli MM10JA
- Added new CRC type for Hitachi A56
- Added new CRC type for Mazda Denso Pxxx
- Fixed CRC calculation for Ford Visteon DCU101
Check the Privacy Policy below to subscribe to Newsletter
